Casio E-CON2 Use Manual page 6

3. Use function keys 1 through 4 to select a Gate Status setting.
• Selecting a gate status causes a screen for specifying the number of samples to appear.
4. Input an integer in the range of 1 to 255 to specify the number of samples.
5. Perform step 8 under "To configure an EA-200 setup using Setup Wizard" on page 2-2 to
finalize the procedure.
To configure a setup for PhotoGate and Smart Pulley
u u u u u
1. Perform the first three steps of the procedure under "To configure an EA-200 setup using
Setup Wizard" on page 2-2.
2. On the "Select Sensor" screen, select [VERN] - [P-Gate] - [Pulley].
• This causes an "Input Distance(m)" screen to appear.
• The distance you specify here is the distance the weight travels after it is released.
• Input a value in the range of 0.1 to 4 to specify the distance in meters.
3. Perform step 8 under "To configure an EA-200 setup using Setup Wizard" on page 2-2 to
finalize the procedure.
k Outputting the Waveform of a Function through the Speaker
Normally, the Setup Wizard helps you configure setups for sensors connected to the EA-200.
If you select [CASIO] - [SPEAKR] - [Y=f(x)] on the "Select Sensor" screen, however, it
configures the EA-200 to output the sound that corresponds to a function that you input and
graph on the calculator.
To configure a setup for speaker output
u u u u u
1. Connect the data communication cable (SB-62) to the communication port of the
calculator and the MASTER port of the EA-200.
2. Display the E-CON main menu (page 1-1), and then press 1(Setup EA-200).
• This displays the "Setup EA-200" submenu.
3. Press b(Wizard). This displays the Setup Wizard initial screen.
2-4
Using the Setup Wizard
20021201