Casio E-CON2 Use Manual page 15

u u u u u To specify microphone sensitivity
1. Move the highlighting to "Sense" and then press one of the function keys describe below.
To select this level of microphone sensitivity:
Low
Medium
High
2. Press w to finalize Trigger Setup and return to the Advanced Setup menu (page 3-1).
u u u u u To specify the trigger threshold value and trigger edge type
Perform the following steps when "Fast", "Normal", or "Clock" is specified as the sampling
mode (page 3-4).
1. Move the highlighting to "Threshold".
2. Press 1(EDIT) to display a dialog box for specifying the threshold trigger value, which is
value that data needs to attain before sampling starts.
3. Input the value you want.
4. Move the highlighting to "Edge".
5. Press one of the function keys described below.
To select this type of edge:
Falling
Rising
6. Press w to finalize Trigger Setup and return to the Advanced Setup menu (page 3-1).
u u u u u To configure trigger threshold, trigger start edge, and trigger end edge settings
Perform the following steps when "Period" is specified as the sampling mode (page 3-4).
1. Move the highlighting to "Threshold".
2. Press 1(EDIT) to display a dialog box for specifying the threshold trigger value, which is
value that data needs to attain before sampling starts.
3. Input the value you want.
4. Move the highlighting to "Start to".
To select this type of edge:
Falling
Rising
5. Press one of the function keys described below.
6. Move the highlighting to "End Edge".
3-7
Using Advanced Setup
Sensor assigned to CH1 or SONIC by Channel Setup
(page 3-3)
Measurement unit supported by assigned sensor
20021201
Press this key:
1(Low)
2(Mid)
3(High)
Press this key:
1(Fall)
2(Rise)
Press this key:
1(Fall)
2(Rise)