Casio E-CON2 Use Manual page 11

2. Use the f and c cursor keys to move the highlighting to the channel whose setting
you want to change.
3. What you need to do next depends on the currently selected channel.
• CH1, CH2, or CH3
Press a function key to display a menu of sensors that can be assigned to the selected
channel.
1(CASIO) ...... Displays a menu of CASIO sensors.
2(VERN) ....... Displays a menu of Vernier sensors.
3(CSTM) ....... Displays a menu of custom probes.
4(None) ......... Press this key when you want leave the channel without any sensor
• SONIC Channel
For this channel, the sensor is automatically set to Motion Sensor (EA-2). However, you
need to configure the settings described below.
1(Meters) ...... Specifies meters as the measurement unit.
2(Feet) .......... Specifies feet as the measurement unit.
K .................. Press to toggle smoothing (correction of erroneous samples) on
4(None) ......... Select this option to disable the SONIC channel.
• Mic Channel
For this channel, the sensor is automatically set to Built-in (External) Microphone.
However, you need to configure the settings described below.
1(Active) ........ Select this option to enable the Mic channel.
4(None) ......... Select this option to disable the Mic channel.
4. Repeat steps 2 and 3 as many times as necessary to configure all the channels you want.
5. After all the settings are the way you want, press w.
• This returns to the Advanced Setup menu.
Note
• When you select a channel on the Channel Setup screen, the sampling range of the
selected channel appears in the bottom line of the screen.
In this example, the range of the temperature sensor assigned to CH2 appears.
3-3
Using Advanced Setup
assigned to it.
("-Smooth" displayed) and off ("-Smooth" not displayed).
20021201