11.Input a percent value for the output frequency value you want.
• To output the original sound as-is, specify 100%. To raise the original sound by one octave,
input a value of 200%. To lower the original sound by one octave, input a value of 50%.
12.After inputting an output frequency value, press w.
• This outputs the waveform between the start point and end point from the EA-200 speaker.
• If the sound you configured cannot be output for some reason, the message "Range
Error" will appear. Note that the supported output range is 200 to 4000Hz. If this
happens, press i to scroll back through the previous setting screens and change the
setup as required.
13.To terminate sound output, press the EA-200 [START/STOP] key.
• Pressing w after terminating sound output returns to the output frequency dialog box in
step 11.
2-6
Using the Setup Wizard
20021201