Casio E-CON2 Use Manual page 48

k Outputting a Specific Range of a Graph from the Speaker
Use the following procedure to output a specific range of a sound data waveform graph from
the speaker.
To output a graph from the speaker
u u u u u
1. On the graph screen, press 6( g ), and then 4(SPKR).
• This displays the trace pointer for selecting the range on the graph.
2. Move the trace pointer to the start point of the range you want to output from the speaker,
and then press w.
3. Move the trace pointer to the end point of the range you want to output from the speaker,
and then press w.
• After you specify the start point and end point, a dialog box like the one shown below
appears on the display.
4. Input a percent value for the output frequency value you want.
• The output frequency specification is a percent value. To output the original sound as-is,
specify 100%. To raise the original sound by one octave, input a value of 200%. To lower
the original sound by one octave, input a value of 50%.
5. After inputting an output frequency value, press w.
• This outputs the waveform between the start point and end point from the EA-200
speaker.
• If the sound you configured cannot be output for some reason, the message "Range
Error" will appear. Note that the supported output range is 200 to 4000Hz. If this
happens, press i to scroll back through the previous setting screens and change the
setup as required.
6. To terminate sound output, press the EA-200 [START/STOP] key.
• Pressing w after terminating sound output returns to the output frequency dialog box in
step 3.
11-11
Graph Analysis Tool Graph Screen Operations
20021201
/