Duplo DocuCutter DPC-400 Operation Manual page 46

Warnings:
 Existed parameters of offsets are factory defaults, which is required to be followed
 All parameters existed on the page after Enter the password are factory defaults.

6. Q & A of Alarms
strictly, otherwise there would occur equipment damages and unexpected risks.
Please do not alter them except under the guide of suppliers. Otherwise, may occur
unexpected equipment damages or personal injuries!
Gradient coefficient is up to +/- 2.5 degrees, uncontrolled shrinking of breadth may
occur if the coefficient is too large.
Alarm
1. Cut file is over the working size of the cutting
table, please select correct machine model
Duplo USA
on
2. Cut file is over valid work area of
46
Solution
Duplo USA