Duplo DocuCutter DPC-400 Operation Manual page 22

ADVANCE_a
Knife Comp: Adjusts the angle of
corner cut
-If the angle is rounded, increase the
value
-If the angle has point, decrease the
value
Wheel offset: If wheel isn't making a
straight line along the X axis. 10
o
units is 1
-Positive rotates counter clockwise
-Negative rotates clockwise
Knife1 Comp: Adjusts the angle of
corner cut
-If the angle is rounded, increase the
value
-If the angle has point, decrease the
value
Pump time: delays the time before
the cutter starts
2 = Default
Cut height: Adjusts the lift up height
of the tool
5mm= Default
ADVANCE
ADVANCE_b
Auto-return: Head returns to set
positions
Off= stays at its current position
after cuts
Back= goes to starting position
Max= goes to the corner of the
document
Pump enable: Automatically
turns on pump before cutting. If
OFF you are required to manually
turn ON pump before cutting.
PG-enter: OFF (default)
Auto-Feed: Automatically feeds
the next sheet
22
ADVANCE_c
Password Input: 8888
Extended Setup button