Putting Into Use - hajdu Smiley SY80R Instructions For Installation And Use Manual

SY80R • SY120R • SY150R
The battery may not be connected
until the commissioning
appliance. The battery must put in
operation by a qualified professional
using the dedicated and marked red
and black lead and the red female
connector (Figure 14.2).
If the display is not operational
after connection, disconnect and
reconnect battery. I the display stays
empty after 2 to 3 attempts, the
battery may have been exhausted
during extended storage. If you
energize the unit, the battery will
charge .
After mounting, making the hydraulic and electrical connections and
filling up the container with water, the appliance can be put into use.
When heating up the first time, have proper operation supervised by a
Before starting its use, fill the hot water tank with drinking water for one
day, and drain the rinsing water in the sewage network. Do not use the
rinsing water for household purposes. The proper use of the system may
7.1. A qualified technician must perform the installation and first start-up of the ap-
pliance, in line with the relevant national regulations in effect, and any other re-
quirement set out by the local governments or public health institutions.
7.2. Open the closing valve (Item 1, Figure 14.3) and the hot water tap, but leave the
cold water tap closed. The incoming water will fill up the tank. Let the water flow
for a few minutes to flush the appliance, then close the tap.
7.3.
Power on the appliance using the main switch. Then the appliance will automati-
cally start heating up to the preset default value, which will be indicated by the
Shower Head
The Shower Head
7.4. During heat-up, excess water may leak through the outlet of the combined safety
valve due to expansion. This pipe must be left open towards the air space.
36 2
of the

7. PUTTING INTO USE

professional.
not be started, but after the steps above.
icon .
icon will flash during the heat-up time
Figure 6.1.-1