hajdu Smiley SY80R Instructions For Installation And Use Manual page 42

SY80R • SY120R • SY150R
9.5.6. Target upper temperature
This is shown only in Spec mode.
The flashing symbol for the top of the container in place
of the first digit indicates that the display shows an ad-
justable value .
The next two digits show the target upper temperature expressed as an integer
degree value, which are followed by the degree symbol and letter „C" in the last
place.
You cannot set lower value than the target lower temperature. You cannot set
higher value than the factory preset maximum temperature (80 °C) either.
9.5.7. Measured lower temperature
The symbol for the bottom of the container is inserted in
place of the first digit.
• Constantly illuminated – the lower heating circuit
is not working .
• „Winding" movement, i.e. the segments light up in
succession – the lower heating circuit is working .
The remaining three digits indicate the lower measured temperature with a deci-
mal point.
9.5.8. Target lower temperature
This is shown only in Spec mode.
The flashing symbol for the bottom of the container in
place of the first digit indicates that the display shows an
adjustable value .
The next two digits show the target lower temperature expressed as an integer
degree value, which are followed by the degree symbol and letter „C" in the last
place.
You cannot set higher value than the target upper temperature. You cannot set
lower value than the factory preset minimum temperature (5 °C) either.
9.5.9. Remaining heating time
In place of the first digit, the display shows the symbol H
(hour) for the remaining heating time.
The remaining three digits indicate the remaining heating
time in minutes .
9.5.10. Stored hot water quantity
Letter „L" in place of the first digit indicates that the re-
maining three digits show the hot water quantity ex-
pressed in litres. The value displayed can be higher than
the capacity of the hot water storage container, for it
means the equivalent water quantity at 40 °C.
42 2