hajdu Smiley SY80R Instructions For Installation And Use Manual page 43

9.5.11. SEt (settings)
If you press and hold down the middle button, the value
Ld 0 will appear on the display indicating the start day
of Legionella disinfection. Day 0 means Sunday, 1 is for
Monday, 2 for Tuesday etc .
The start hour of Legionella disinfection .
Display brightness (1-15)
Start time of economy mode (minutes)
Default display value (1-31). For alternating display, add
up the number of display data, and enter the sum ob-
tained. (For example, 1+2+4=7 hour:minute, measured
upper temperature, measured lower temperature dis-
played in succession.) After one minute idle time, the
display shows the data according to the value set here.
time (Hour:Minute)
1
Measured upper temperature
2
Measured lower temperature
4
Remaining heat-up time (minutes)
8
Stored hot water quantity (l)
16
Battery charging status (read only)
1 End of charging cycle
2 Charging in progress
3 The electronic system is run from battery .
Upper temperature set for active alarm state
Lower temperature set for active alarm state
EN
3 4 3