Table of Contents
Advertisement
WARNING
!
Make sure that the CPAP , APAP , or bilevel device is switched off at the
•
power outlet before connecting the HumidAire 2i.
Make sure the power cord and plug are in good condition and the
•
equipment is not damaged.
5
Place the device on a firm, flat surface near your bed. Make sure that it is placed
at a level lower than your sleeping position so that any excess condensation
drains back into the water chamber.
CAUTION
!
Be careful not to place the device where it can be bumped into and knocked
over.
WARNING
!
Do not fill the water chamber while it is attached to the docking station and
the CPAP, APAP or bilevel device.
6
Turn the water chamber so that the air outlet points up. Over a sink, carefully fill
the water chamber through the air outlet up to the maximum water level mark
shown on the side of the water chamber base.
Air outlet
The HumidAire 2i should be filled with fresh water before use. Always ensure
that the water chamber is clean. See "Cleaning and Maintenance" on page 13.
WARNING
!
Do not overfill the water chamber, as water may enter the CPAP, APAP, or
bilevel device and air tubing.
CAUTION
!
Do not use additives, in particular aromatic additives (eg, scented oils and
perfumes). They may reduce the humidification output of the device and/or
cause deterioration of the water chamber materials.
Maximum
water level
mark
Preparing For Use
7
Advertisement
Table of Contents
