Table of Contents
Advertisement
To activate the Warm-Up Feature:
1. Depending on your model, press the Right (warmup) key or the Enter key on
the control panel.
2. The Warming screen (which may vary in appearance according to your
model) will be displayed to indicate that the Warm-Up feature is activated.
3. While the HumidAire 2i is in Warm-Up mode you can:
•
•
•
3
Turn the humidity control dial to the desired setting. The control dial is labelled
as shown in the diagram below. A setting of 1 provides minimum humidification,
and a setting of 6 delivers maximum humidification. The setting marked with a
switches heated humidification off.
Initially, set the control dial to 3. If necessary adjust the control dial up or down
to find the most comfortable and effective setting. You can adjust the humidity
setting at any time.
Your aim is to have moist air delivered at your mask while avoiding condensation
in the air tubing. Your ideal setting will depend on the temperature and humidity
of the surrounding air.
See "Helpful Hints" on page 12 for further tips on the correct humidity setting.
10
AUTOSET SPIRIT
menu
warmup
WARMING
menu
Start treatment at any time by pressing the Front or the Enter key
(depending on your model).
Access the menus by pressing the Left (menu) key. For the
VPAP™ III ST-A with QuickNav™, use the Up/Down and Enter keys to
access the menus.
Stop the Warm-Up feature at any time by pressing the Right (exit) key
(this does not apply to the VPAP III ST-A with QuickNav).
Right key
(warmup)
exit
Enter key
Advertisement
Table of Contents
