Positive Airway Pressure (PAP) therapy. Indications for use The H4i is indicated for humidification of the air delivered from a ResMed compatible CPAP, bilevel or non-invasive ventilation device. The H4i is for use only as recommended by a physician.
System setup Align your H4i with your flow generator and push them together until they click into place. Connect the power cord to the socket on the rear of your flow generator. Plug the other end of the power cord into the power outlet.
Fill with fresh, clean water up to or below the maximum water level mark. Note: The water chamber must be removed from the H4i before it is filled or water may enter the flow generator. The spill guard must also be in place.
If the humidifier is heating, the related symbol is displayed at the top of the LCD screen. Note : The H4i can only be used when the device is connected to mains power supply. CAUTION H4i cannot be used for treatment pressures exceeding 35 cm H Starting your treatment Turn the humidity control dial to three ( ).
• Take care when handling your H4i. The water and the water chamber base may both be hot. Allow 10 minutes for the heater plate and any excess water to cool.
Page 9
Cleaning the H4i Water chamber Daily Wash the water chamber, spill guard, tub plate and tub plate seal in warm water, using a mild detergent. Use the yellow cleaning plug to assist in the cleaning process (see steps 1 to 4). Rinse thoroughly in clean water and allow them to dry away from direct sunlight.
CAUTION • Do not use any of the following to clean any part of the H4i as these solutions may cause damage and reduce the life of the product: – bleach, chlorine-, alcohol- or ammonia-based solutions – moisturizing, antibacterial or glycerine based soaps –...
You may need to adjust your humidity setting from season to season. The use air tubing? of a ResMed Tubing Wrap can help reduce the effects of condensation. Do I have to use Using distilled water will maximize the life of the water chamber and reduce mineral distilled water deposits.
The air tubing is not connected Connect the air tubing as described in properly. “Setting up your H4i for use” on page 1. The air tubing is blocked, pinched Unblock or free the air tubing. Check the air or punctured.
Disconnect the docking station from the PAP device and allow the docking station to drain and dry before using. • Do not operate the H4i if it is not working properly or if any part of the PAP device or H4i has been dropped or damaged. •...
• Portable diagnostic/screening devices This warranty is only available to the initial consumer. It is not transferable. If the product fails under conditions of normal use, ResMed will repair or replace, at its option, the defective product or any of its components.
Page 15
This warranty gives you specific legal rights, and you may also have other rights which vary from region to region. For further information on your warranty rights, contact your local ResMed dealer or ResMed office.
Page 16
Filling the Water Chamber / Remplissage du réservoir / Cómo llenar la cámara de agua / Como encher o compartimento de água 248671/1 2013-02 USER AMER MUL Global leaders in sleep and respiratory medicine www.resmed.com...