Table of Contents
Advertisement
2. As shown below, position the tub plate so that the open side is facing down.
Then firmly press the tub plate down into the water chamber.
Note: The tub plate will not fit into the water chamber if it is facing up. Before
fitting the tub plate, make sure the O-ring is fitted snugly inside the groove of
the tub plate.
7
Cleaning
W
C
ATER
HAMBER
Wash the lid, seal, cross-member and base in warm water using a mild detergent
or in a dishwasher. Rinse them thoroughly with clean water and allow them to
dry away from direct sunlight. Do this daily or after each use. Inspect the water
chamber for wear and deterioration. Replace any damaged parts.
CAUTION
!
Do not use any of the following to clean any part of the HumidAire 2i. These
solutions may cause damage and reduce the life of the product.
bleach, chlorine-, alcohol-, or ammonia based solutions
•
moisturizing, antibacterial, or glycerine based soaps
•
water softening and descaling agents
•
If using a dishwasher, avoid heavy duty or high temperature cycles (greater
than 158°F). Do not use strongly alkaline detergents and rinse aids.
D
S
OCKING
TATION
Wipe the outside of the docking station with a damp cloth. Do this periodically.
8
Reassembling the Water Chamber
When all the water chamber parts are clean and dry, reassemble the water
chamber:
1. Place the cross-member on its supports inside the water chamber base.
Supports
Tub plate
Notches
Supports
Cleaning and Maintenance
15
Advertisement
Table of Contents
