Configuration (Ddc); Assembly Mount - Bosch KTS 5 Series Original Instructions Manual

4.4

Configuration (DDC)

i
The function of the DDC (Diagnostic Device Configu-
ration) software is to configure, activate and test the
KTS modules.
1. Starting DDC ("Start >> Programs >> ESI[tronic] >>
Diagnostic Device Configuration").
2. Add the KTS module via "New".
i
Other procedures for configuration concerning the
initial start-up are described in the online help. Use
<Help> to open the online help. All other important
information concerning DDC is found here as well.
i
If you have any questions which cannot be answered
by the online Help, please contact the ESI[tronic]
service hotline directly.
Robert Bosch GmbH
Initial start-up | KTS 530 / 540 / 570 (KTS 5 Series) | 25
4.5

Assembly mount

The mount included with the delivery allows fastening
and loosening the KTS modules on the Bosch trolley
(possible as of production date 03-2006 only).
1. Screw in the three fillister head screws on the Bosch
trolley (see Fig. 4).
Fig. 4: Assembly mount
2. Using the sheet-metal screws included with the de-
livery, screw the mount onto the KTS module (holes
for mounting are on the rear of the module).
3. Correct the screw penetration of the fillister head
screws on the vehicle so that the KTS modules are
solidly and securely seated in position following
installation.
en
|
1 689 989 289 2014-12-04