Settings Using A Web Browser (Remote Ui) - Canon imageCLASS MF6500 Series Advanced Manual

Advanced Fax
1
Features
Advanced Copy
Features 2
Network
3
Remote UI
4
System Monitor
5
Reports and Lists
6
Troubleshooting
7
Appendix
8
Table of Contents
Index
Startup Time Settings
If you connect the machine to a switching hub, it may not be able
to connect to a network even though your network settings are
set correctly.
This occurs because the spanning tree process performed
between switching hubs prevents them from communicating
with each other immediately after the machine connects to a
switching hub.
In this case, use the following procedure to delay the startup of
network communication.
1.
Press [Additional Functions].
2.
Use [ ] or [ ] to select <SYSTEM
SETTINGS>, then press [OK].
3.
Use [ ] or [ ] to select <NETWORK
SETTINGS>, then press [OK].
4.
Use [ ] or [ ] to select <STARTUP TIME
SET.>, then press [OK].
Back Previous
5.
Use [ ] or [ ] to set the time period
required to delay the startup of network
communications for the machine, then press
[OK].
You can enter the value from 0 to 300 (seconds).
6.
Press [Stop] to return to standby mode.
7.
Restart the machine.
■
Settings Using a Web Browser (Remote
UI)
NOTE
– Before using the Remote UI, make sure that <USE HTTP> is set to
<ON> in <TCP/IP SETTINGS> in <NETWORK SETTINGS> located
in the <SYSTEM SETTINGS>, and <REMOTE UI> is set to <ON> in
the <SYSTEM SETTINGS> menu. (See "HTTP," on p. 3-7, and
Chapter 4, "Remote UI".)
– If you are using a connection via a proxy server, use the following
settings. (The settings differ depending on the network environment.)
When configuring your web browser to use the proxy server, add the
IP address of the machine to Exception (the address not using the
proxy server).
TOP
Next
3-19