Canon imageCLASS MF6500 Series Advanced Manual page 59

Advanced Fax
1
Features
Advanced Copy
Features 2
Network
3
Remote UI
4
System Monitor
5
Reports and Lists
6
Troubleshooting
7
Appendix
8
Table of Contents
Index
19.
Use [ ] or [ ] to select from <IP
ADDRESS 1> through <IP ADDRESS 4>, then
press [OK].
20.
Confirm that <START IP ADDRESS> is
displayed, then press [OK].
21.
Use the numeric keys to enter the start IP
address, then press [OK].
22.
Confirm that <END IP ADDRESS> is
displayed, then press [OK]
23.
Use the numeric keys to enter the end IP
address, then press [OK].
NOTE
To enter another IP address range, repeat steps 19 to 23.
After you specified the <END IP ADDRESS> of <IP ADDRESS
4>, confirm that <RX MAC ADD SET.> is displayed, press [OK],
then skip to step 26.
24.
Use [Additional Functions] so that <SET IP
ADD RANGE> in <TCP/IP SETTING> is
displayed.
Back Previous
25.
Use [ ] or [ ] to select <RX MAC ADD
SET.>, then press [OK].
26.
Use [ ] or [ ] to select <ON> or <OFF>,
then press [OK].
<OFF>: Disables a MAC address filter. Skip to step 29.
<ON>: Enables a MAC address filter.
NOTE
If you select <ON>, you will be unable to access from MAC
addresses which have not been specified.
27.
Use [ ] or [ ] to select from <PERMIT
RX ADD1> through <PERMIT RX ADD5>, then
press [OK].
28.
Specify the MAC addresses to allow access
to, then press [OK].
Repeat steps 27 and 28 to specify other MAC addresses.
29.
Press [Stop] to return to standby mode.
30.
Restart the machine.
TOP
Next
3-18