Nortel Meridian 1 Manual page 77

Procedure 22
M2616CT Wall mounting
The M2616CT base is equipped with a reversible footstand that allows you to
mount the telephone on the wall. The procedure is described below:
1 Remove the handset and place the telephone upside down on a level
work surface covered with soft material to prevent damage to movable
keys and the telephone face.
2 Disconnect all cords from the set.
3 Remove the two screws from the footstand assembly.
4 Unsnap the footstand assembly by pressing inward at the back of the
footstand where it meets the base, and pulling upward.
5 Rotate the footstand 180 degrees and screw the footstand back into
place to the set's bottom cover.
6 Tighten all screws and replace all cords.
7 Mount the telephone on the wall using the wall-mount holes proved on
the bottom of the footstand.
Procedure 23
M2616CT Meridian 1 system administration
To configure the M2616CT set refer to X11 Software input/output guide
(553-3001-400) for complete information and procedures on LD11 to
configure the Meridian Digital Telephone. For the Locator key (key 14) to
function, do not assign a feature to this key. Handsfree is required for the
M2616CT to function properly.
Procedure 24
M2616CT Handset Registration to Base Unit
Each M2616CT handset is automatically registered to its respective base unit.
In cases where a substitute handset is required for troubleshooting purposes,
a different M2616CT handset can be reregistered by placing the handset
on-hook, and unplugging, then re-plugging in the AC power adapter and
telephone line cord.
Telephones
Telephone and attendant console installation
Page 65 of 224