Nortel Meridian 1 Manual page 202

Telephone and attendant console installation
Table of Contents

Advertisement

Page 190 of 224
553-3001-215 Standard 10.00 June 1999
Add-on modules
Installing the display board
9
Place the J1 connector of the display board over the P2 pins of the
telephone (see Figure 57). Press down slowly until J1 slides onto the
P2 pins and is firmly seated.
Note: If the center screw is included, do not perform step 10.
10
Insert the self-tapping Phillips-head screw supplied with the display
into the mounting hole (near the top). Tighten firmly with a #1 Phillips
screwdriver.
Installing the display
11
Place the display face-down near the top of the telephone and align the
two mounting holes of the display with the mounting holes in the
telephone.
12
Insert two self-tapping Phillips-head screws from the faceplate into the
mounting holes; tighten them firmly with a #1 Phillips screwdriver.
13
Install the power supply board (see Procedure 80). This step is not
necessary on M2616 unless you have other hardware options.
14
Fold the ribbon cable near the connector to align it with the J2 pins on
the display board, ensuring that the notch on the ribbon cable is facing
toward the display board. Carefully work the ribbon cable connector
onto the J2 pins until firmly seated. Route the cable flat beside the
power supply board, gathering excess cable under the display. Be
careful not to press the cable beneath the alignment posts or studs of
the base. See Figure 57.
Note: Do not allow R5 on the power supply board to become bent
during this procedure.
15
Replace the base. If the telephone is equipped with an MPDA or MCA,
reconnect the data cable to the base telephone jack and replace the
footstand (ensuring that the MPDA or MCA cable does not get pinched
between the base and the footstand). Make sure the footstand is firmly
seated in the base.
Note: Place the label supplied with the display on the outside of the
bottom cover of the telephone. This allows proper identification and
tracking of the option level of the set.

Advertisement

Table of Contents
loading

This manual is also suitable for:

M2317M3000M2616ct

Table of Contents