Nortel Meridian 1 Manual page 54

Page 42 of 224 Telephones
553-3001-215 Standard 10.00 June 1999
Procedure 13
Removing the SL-1 telephone faceplate
1 Place the SL-1 telephone on a desk with the front edge slightly beyond
the edge of the desk.
2 Insert a paper clip into each release hole in the front edge of the
telephone housing, and pry the faceplate open (see Figure 15).
3 Lift the faceplate off.
4 Unscrew the captive retaining screws securing the cover to the
housing, and remove the cover.
Procedure 14
Installing the M2000 digital telephones
1 Complete the wiring and cross-connections as shown in Figure 16
before connecting the telephone(s) to the connecting block(s).
2 Place the telephone upside down on a number of sheets of soft, clean
paper on a solid, level work surface to prevent damage to movable
keys and the telephone face.
3 Connect the handset cord 4-conductor TELADAPT connectors to the
handset and the telephone and snap into place.
4 After connecting the handset cord to the connector in the base of the
telephone, turn the smooth side of the handset cord up (away from
telephone base) before tucking it under the restraining tab to ensure
that the telephone will sit level on the desk after installation is
complete.
5 Connect the 6-conductor line cord to the telephone base, and route it
under the tabs.
6 Turn the telephone right side up and place it in the normal operating
position.
7 Designate buttons for key labels.
8 Insert the line cord TELADAPT connector into the connecting block
and snap it into place.
Test the telephone using LD 31. See X11 input/output guide
9
(553-3001-400).