Nortel Meridian 1 Manual page 69

Procedure 19
Installing the M3000 Touchphone set
1 Place the Touchphone set upside down on a number of sheets of soft,
clean paper on a solid, level work surface to prevent damage to
movable keys and the telephone's face.
Installing Asynchronous Data Option (ADO)
2 Remove the four self-tapping screws that fasten the stand to the
Touchphone body. Lift the stand off the locating posts in a straight,
upward motion.
3 Snap the ADO into the rear of the Touchphone body, with the ribbon
cable and header connector protruding from the front of the ADO
housing.
4 Plug the 34-pin header connector at the end of the ribbon cable into
the receptacle located in the body of the Touchphone set and press
firmly.
Assemble the Touchphone set and Stand
5 Place the stand over the Touchphone body and position over the four
locating posts.
6 Using the four self-tapping screws removed earlier, fasten the stand
securely to the Touchphone body.
Connect the Cords
7 If the handset is not already connected to the Touchphone set, connect
the cord's TELADAPT connector to the Touchphone body. Route the
cord under the plastic tabs in the stand and out the exit slot. Snap the
other end of the cord into the handset receptacle.
8 Connect the line cord TELADAPT connector to the Touchphone body
jack, and route the cord through the channel in the stand. Connect the
other end of the line cord to the baseboard or wall connector.
9 Plug the power transformer cord into the mating connector in the
Touchphone body and press firmly.
Telephones
Telephone and attendant console installation
Page 57 of 224