Table of Contents
Advertisement
Chapter 8: Hardware Installation for Synchronous Mirroring
5.
Connect the secondary host bus adapter for each host at this site to an available
port in zone 2 of switch 1A.
Figure 9 Host Bus Adapter Connections to Fibre Channel Switches
6.
Connect controller port A1 of the storage array to an available port in zone 1 of
switch 1A.
The first figure following step 9 shows the storage array connected to Fibre
Channel switches that is described in step 6 through step 9. The second figure
following step 9 shows the cabling configuration schematically with four host
ports on each of two controllers in each controller tray.
7.
Connect controller port B1 of the storage array to an available port in zone 2 of
switch 1A.
8.
Connect controller port A2 of the storage array to an available port in zone 3 of
switch 1A. In a four-host-port system, connect controller port A4.
205
Hide quick links:
Advertisement
Table of Contents
