Entering Dimensions; Linear Dimensions; Square And Cubic Dimensions - Calculated Industries Construction Master 5 Reference Manual

ENTERING DIMENSIONS

Linear Dimensions

When entering Feet-Inch values, enter
dimensions from largest to smallest —
Feet before Inches, Inches before
Fractions. Enter Fractions by entering the
numerator (top number), pressing /
(Fraction Bar key) and then the denomina-
tor (bottom number).
Note: If a denominator is not entered, the frac-
tional setting value is used.
Examples of how linear dimensions are
entered (press o after each entry):
DIMENSION
5 Yards
5 Feet 1-1/2 Inch 5 f 1 i 1 / 2
17.5 Meters

Square and Cubic Dimensions

Examples of how Square and Cubic
dimensions are entered (press o after
each entry):
DIMENSION
5 Cubic Yards
130 Square Feet 1 3 0 f f
33 Square Meters 3 3 m m
P R
OCKET EFERENCE
KEYSTROKES
5 y
1 7 • 5 m
KEYSTROKES
5 y y y
G
UIDE
— 13