Table of Contents
Advertisement
ENTERING DIMENSIONS
AND UNITS
When entering feet-inch dimensional
values, you must enter the largest
dimension first — feet before
inches, inches before fractions. To
enter fractions of an inch, enter the
numerator (value above the line), press
(Fraction Bar key) and then enter
/
the denominator (value below the line).
For all other units of measurement,
you can only enter whole numbers or
decimal numbers. You cannot enter
combinations of units (for example,
you cannot enter 12 meters 6
centimeters 4 millimeters).
Linear Dimensions
The following examples show how
linear dimensions are entered.
Note: The
each of the entries to clear the display.
diMension
5 feet
1/2 inch
numerator
fraction bar
denominator
O
key should be pressed after
KeysTroKe
5f
1/2
3
—
16
Advertisement
Table of Contents
