Entering Dimensions; Entering Linear Dimensions; Entering Square/Cubic Dimensions - Calculated Industries Sheet Metal/HVAC Pro Calc User Manual

ENTERING DIMENSIONS

Entering Linear Dimensions

When entering Feet-Inch-Fraction values, enter dimensions from
largest to smallest — e.g., Feet before Inches, Inches before
Fractions. Enter Fractions by entering the numerator (top), pressing
/ (Fraction bar key) and then the denominator (bottom).
Note: If a denominator is not entered, the fractional setting value is used.
Examples (press o after each one):
DIMENSION
5 Feet 1-1/2 Inch
17.5 Meters
32 Millimeters

Entering Square/Cubic Dimensions

Your calculator lets you easily enter Square and Cubic values.
Simply press a dimensional unit key two times to label a number as
a Square value, or three times to label a Cubic value.
Note: If you pass the desired dimensional format, keep on pressing the dimensional
unit key until the desired result is displayed.
Enter Square and Cubic dimensions in the following order:
(1) Enter numerical value (e.g., 1 0 0).
(2) Press desired unit key (e.g., f) to label value as "linear."
KEYSTROKE
o o
1 0 0 f
(3) Second consecutive press of unit key (e.g., f) labels value as
"Square."
KEYSTROKE
o o
1 0 0 f f
(4) Third consecutive press of unit key labels value as "Cubic."
KEYSTROKE
o o
1 0 0 f f f
Note: Feet-Inch format cannot be used to enter Square or Cubic values.
5 f 1 i 1 / 2
1 7 • 5 m
3 2 Ç m
100
100
U ' G
SER S
KEYSTROKES
DISPLAY
0.
100
FEET
DISPLAY
0.
SQ FEET
DISPLAY
0.
CU FEET
— 25
UIDE