Entering Dimensions - Calculated Industries Construction Master IV User Manual

Fractional
Rounding
Settings: When your calculator is in a

ENTERING DIMENSIONS

All examples are performed in Metric Mode
(press [Rcl] [x] to see "METR" on display).
default condition (after a battery
change or full reset), it is set to
round fractional values to the near-
est 1/16 of an inch. However, you
may program your preference for
six different accuracy levels which
remain in permanent memory
until revised or reset. To change the
fractional rounding, press:
[Conv] 1 Fraction set to 1/16
[Conv] 2 Fraction set to 1/2
[Conv] 3 Fraction set to 1/32
[Conv] 4 Fraction set to 1/4
[Conv] 6 Fraction set to 1/64
[Conv] 8 Fraction set to 1/8
15 — User's Guide