(repeats options)
Third press of
(Volume displays)
(repeats options)
Fourth press of
(Meter Linear displays)
(floating point)
(repeats options)
Fifth press of :
(Decimal Degree displays)
(floating point)
(repeats options)
Sixth press of
(Fractional mode)
(repeats options)
Seventh press of
(Mathematical Operation)
(repeats options)
EnTERinG dimEnSionS
linear Dimensions
When entering feet-inch values, enter dimensions from largest
to smallest — feet before inches, inches before fractions. Enter
fractions by entering the numerator (top number), pressing
(Fraction Bar key) and then the denominator (bottom number).
Note: If a denominator is not entered, the fractional setting
value is used.
:
:
:
:
Std.
vol Std.
vol 0. cu fEET
vol 0. cu m
vol Std.
mETR 0.000 m
mETR floAt m
mETR 0.000 m
DEG 0.00º
DEG floAt
DEG 0.00º
fRAc Std.
fRAc conSt.
fRAc Std.
mATh ordEr
mATh chA1n
mATh ordEr
U
'
G
— 9
ser
s
Uide