Image Access WideTEK 36CL Setup Instructions page 85

The recovery procedure is a simple, multi-step process.
Step
2.1 - Scanner with Recovery Key
2.2 - Scanner with STOP button
3 - All scanners
4.1 - Scanner with Recovery Key
4.2 - Scanner with STOP key
Action
Wait for the scanner to shut down,
then connect the Recovery Key to
the DB9 connector, on the back of
the scanner.
Wait for the scanner to shut down.
Make sure the main power is on.
Turn on the scanner using the
power button.
Press and hold the red STOP button
(1) before switching on!
Switch on the scanner via the
power button (2).
Note: During the switch-on process,
the red STOP button (1) must be
pressed and held until the red
button lights up permanently!
Perform setup
85