How To Turn Transmitter Power On/Off - FUTABA T16IZ Short Manual

How to turn transmitter power ON/OFF

When turning on the power, the T16IZ transmitter will begin emitting RF automatically after it confirms
the surrounding RF conditions. The status of the transmitter is displayed by LED at the upper part of the
front of a T16IZ.
Power ON
Throttle Stick Low
If the "Thr position" alarm displays
*If the throttle stick is in the high position when the
power is turned ON
Warning alarm
If the power switches are turned off in the opposite order the model may unexpectedly run out of control and
cause a very dangerous situation.
Turning on the power switches
1. Turn on the transmitter power switch.
2. Turn on the receiver or speed control power switch.
ON
ON
*If THR stick is high, a WARNING screen will appear. Another warning will appear if a power
supply is attached. (In Multicopter mode, the THR position alarm will not appear.)
Power Switch ON
Push
Power OFF
Power Switch
When the alarm activates, lower the throttle stick
before turning the receiver power ON.
*If the power is turned ON when the idle-up, air brake,
etc., switches are ON, the above warning will display.
Ensure the relevant switches are turned OFF.
Tap this to stop the alarm
a n d R F s i g n a l . O n l y p a n e l
screen operation is active, the
transmitter will not link to any
receiver.
Turning off the power switches
Always be sure the motor/engine is stopped.
1. Turn off the receiver or speed control power switch.
2. Then turn off the transmitter power switch.
OFF
Long Push
OFF
15