FUTABA T16IZ Short Manual page 8

micro SD Card (Commercial Product) Handling Precautions
WARNING
Never disassemble or modify the SD
Do not bend, drop, scratch or place heavy objects on
the SD card.
If smoke or an abnormal odor emanates from the card,
immediately turn off the transmitter power.
CAUTION
Since the SD card is an electronic device, be careful of
static electricity.
■ Static electricity may cause erroneous operation or other
trouble.
Do not use the SD card near radio and television sets,
audio equipment, motors and other equipment that
generates noise.
■ Doing so may cause erroneous operation.
Do not store the SD card in the following places:
・ Where the humidity is high
・ Where the temperature difference is severe
・ Where it is very dusty
・ Where the card will be exposed to shock and vibration
・ Near speakers and other magnetic devices
Storage and Disposal Precautions
WARNING
Keep wireless equipment, batteries, aircraft, etc.
away from children.
CAUTION
Do not store wireless devices in the following places:
・ Where it is extremely hot (40℃ [104 ℉ ] or higher) or
cold (-10℃ [14 ℉ ] or lower)
・ Where the equipment will be exposed to direct sun-
light
・ Where the humidity is high
・ Where vibration is prevalent
・ Where it is very dusty
・ Where the device may be exposed to steam and heat
Other Precautions
CAUTION
Do not directly expose plastic parts to fuel, oil, ex-
haust gas, etc.
■ If left in such an environment, the plastic may be damaged.
■ Since the metal parts of the case may corrode, always keep
them clean.
Join the Academy of Model Aeronautics.
■ The Academy of Model Aeronautics (AMA) provides guidelines
and liability protection should the need arise.
8
*Read the instruction manual supplied with the SD card for details.
card. Do not use the SD card where it may be exposed to
water, chemicals, oil, or other fluids.
■ Doing so may cause a fire or electric shock by short circuiting.
Do not insert foreign matter into the transmitter card slot.
■ Doing so may cause erroneous operation.
Do not expose the card to shock and vibration and do
not remove the card from the card slot while data is be-
ing written or read.
■ The data may be damaged or lost.
When the device will not be used for a long time, re-
move the batteries from the transmitter and aircraft and
store them in a dry place where the temperature is be-
tween 0℃ and 25℃ [32 ℉ and 77 ℉ ].
■ Leaving batteries inside your model and radio when they are not
being used for long periods will result in battery deterioration,
liquid leakage and other damage.
Always use genuine Futaba products such as trans-
mitter, receiver, servo, ESC, etc.
■ Futaba is not responsible for damage sustained by combination
with parts other than Futaba Genuine Parts. Use the parts
specified in the instruction manual and catalog.
● Recorded data
The data recorded on the SD card cannot
be compensated regardless of the contents
or cause of the trouble or obstruction.
Futaba does not perform data restoration
or recovery work.