Procedures To Install And Wire Options On A Drive - YASKAWA SI-EN3 Installation Manual

5 Installation Procedure
WARNING
Connections that are too loose or too tight can cause incorrect operation and damage to the drive.
Incorrect connections can also cause death or serious injury from fire.
NOTICE
correct electrostatic discharge (ESD) procedures. If you do not follow procedures, it can cause ESD
damage to the drive circuitry.
NOTICE
voltage. Incorrect equipment sequencing can cause damage to the drive.
NOTICE
You can cause damage to the drive and connected equipment.
NOTICE
can cause the drive or option to function incorrectly.
NOTICE
can cause malfunction or damage to the equipment.
NOTICE
the drive and connecting peripheral devices. Incorrect connections can cause damage to the option.
◆

Procedures to Install and Wire Options on a Drive

Refer to the following table to check the procedures to install and wire the option on a
drive.
Table 5.1 Procedures to Install and Wire Options on a Drive
Product Series
A1000
D1000
R1000
U1000
U1000L
Z1000U
Z1000
GA500
GA700
GA800
CR700
18
Fire Hazard. Tighten all terminal screws to the correct tightening torque.
Damage to Equipment. When you touch the option, make sure that you observe
Damage to Equipment. Do not de-energize the drive while the drive is outputting
Do not operate a drive or connected equipment that has damaged or missing parts.
Use Yaskawa connection cables or recommended cables only. Incorrect cables
Damage to Equipment. Correctly connect the connectors. Incorrect connections
Damage to Equipment. Make sure that all connections are correct after you install
Procedures to Install and Wire
Options on a Drive
Procedure A
Procedure A
Procedure A
Procedure A
Procedure A
Procedure A
Procedure B
*1 *2
Procedure C
Procedure C
Procedure C
YASKAWA TOEP C730600 92A EtherNet/IP Installation Manual
Page
19
19
19
19
19
19
25
-
31
31
31