Grandstream Networks GXV3350 Administration Manual page 67

IPv6
IPv6 Address
DNS Server 1
DNS Server 2
Static IPv6 Address
IPv6 Prefix Length
Preferred DNS Server
IPv4 Address Type
IP Address
Subnet Mask
Default Gateway
DNS Server 1
DNS Server 2
Layer 2 QoS
802.1Q/VLAN Tag
(Ethernet) for VoIP Calls
802.1x Mode
802.1x mode
802.1x Identity
802.1x Secret
CA Certificate
Client Certificate
Note: When Different Networks for Data and VoIP Calls set to Yes, then
this option will be applied for Data.
The setting needs reboot to take effect.
Configures the appropriate network settings on the phone.
Users could select from "Auto-configured" or "Statically configured".
Configures the primary DNS IP address.
Configures the secondary DNS IP address.
Enter the static IPv6 address in "Statically configured" IPv6 address type.
Enter the IPv6 prefix length in "Statically configured" IPv6 address type.
Default is 64.
Users could select "DHCP" or "Static IP".
• DHCP: Obtain IP address via a DHCP server in the LAN. All domain
values for static IP/PPPoE are unavailable, even though the values have
been saved in the flash.
• Static IP: Manually configures IP Address, Subnet Mask, Default Router's
IP Address, DNS Server 1 and DNS Server 2.
By default, it is set to "DHCP".
Defines the phone's static IP address if the static IP is used.
Determines the network's subnet mask if the static IP is used.
Defines the network's gateway address if the static IP is used.
Configures the primary DNS IP address if the static IP is used.
Configures the secondary DNS IP address if the static IP is used.
When Different Networks for Data and VoIP Calls set to Yes, then this
option will be applied for VoIP traffic. Assigns the VLAN Tag of the Layer
2 QoS packets for Ethernet for VoIP Calls. The Default value is 0.
Enables and selects the 802.1x mode for the phone system. The supported
802.1x modes are: EAP-MD5, EAP-TLS, EAP-PEAP
The default setting is "Disable".
Enters the identity information for the selected 802.1x mode. (This setting
will be displayed only if 802.1 X mode is enabled).
Enters the secret for the 802.1x mode. This option will appear when 802.1x
mode is EAP-MD5 or EAP-PEAP.
Uploads the CA Certificate file to the phone. (This setting will be displayed
only if the 802.1 X mode is enabled)
Loads the Client Certificate file to the phone. (This setting will be displayed
only if the 802.1 X TLS mode is enabled)
GXV3350 Administration Guide
Version 1.0.3.27
P a g e | 67