Table of Contents
Advertisement
Standard Set-up Procedures
a) Locate Point A. Place the transit so that it is behind the Piper and in line with the
centerline of the pipe to be laid.
b) Locate Point B. Look through the transit and lock it on-line with the next manhole
point.
c) Locate Point C. Tilt the transit down to see the Piper. Move the Piper until the
pivot point on the top of the Piper is in line with the centerline of the pipe to be
laid.
•
Set the elevation. Move the Piper up or down on the (optional) trivet until the
required height is set. (Choose the most convenient method for determining the
cut-to-invert distance.)
•
Set the line. Locate Point D. Using the Transit, place a new stake approximately
five meters (15 feet) in front of the Piper. Look throught the transit and move
the beam using the LEFT and RIGHT buttons on the Remote until the beam hits
the stake and intersects the transit's crosshairs.
46
Advertisement
Table of Contents
