Table of Contents
Advertisement
3.8
a
b
c
Basic Operation
Alignmaster (Piper 200 only)
Alingmaster is a function of the Piper 200 only.
When the Alignmaster button (a) is pressed, the Piper will begin a search
routine to find located and stop on the target. This function is normally used
for second day setups to quickly find the beam in the previous day's work.
Procedure for using Alignmaster:
•
Position the target assembly in the end of the last piece of pipe with the two
reflective strips on the inside of the pipe, facing the laser.
•
Roughly align the laser beam in the pipe to the target assembly.
•
Press the ALIGNMASTER button (a). When pressed the laser will scan left and
right until the target is found. While searching the main operating screen is
replaced with a blinking target (b) indicating that Alignmaster is working.
•
If the search routine is successful, the target will remain on the screen for an
additonal fiThe beam can now be fine positioned to the center of the target
using the LEFT or RIGHT arrow buttons (c) on the laser or the remote control.ve
seconds (not blinking).
•
The beam can now be fine positioned to the center of the target using the LEFT
or RIGHT arrow buttons (c) on the laser or the remote control.
37
Advertisement
Table of Contents
