Modena Rapido Series User Manual Book page 10

Ignition/Operation
1. Ignition. After finishing the preparation, open the hot water outlet valve and the water heater will
make "pop" sound, then the hot water will immediately flow out. If the water heater cannot be
ignited at once, switch the hot water outlet valve off and restart it after 15 – 20 seconds.
2. Outlet Water Temperature Controller. Turn the Flame Controller Knob to "Max" position or turn
the Water Volume Controller Knob to "High" position, the outlet water temperature will increase.
On the contrary. Rotate the flame controller knob to "Min" position or turn the water volume
controller knob to "Low" position, and then the outlet water temperature will decrease.
Discontinuing the Use
1. Turn the hot water outlet valve off, and the water heater will automatically shut down.
2. Turn the water inlet valve off.
3. Turn the gas input valve off.
Warning!
If the water heater is used again after a while, do not wash your body with the water
which comes out first. The hot water temperature inside the water heater will be
very high if the water heater is not used for a while. Let the hot water out for a few
second before applying it to your body to avoid scalding.
10