Badger Meter FC-5000 User Manual page 33

4� Highlight CH1 OELAY PAOAMETEO and press ENTEO� The parameters vary,
depending on the mode you selected� The parameters are:
Parameter
Output Source
Scaling Factor
Units
Min On-Time
Latching
Set High
Set Low
Set Delay
Release Delay
Override
5� Highlight OUTPUT SOUOCE and press ENTEO� One or more options are
available, depending on the flow computer model�
6� Highlight an output source and press ENTEO.
7� Press BACKSPACE to return to the CH1 Relay Parameter menu�
8� To edit the remaining parameters:
a� Highlight the parameter and press ENTEO�
b� Use the soft keys and numeric keypad to enter a value and press ENTEO to
save the value�
9� On the confirmation screen, press ENTEO to confirm the change�
Clearing a Latched Oelay
To clear a relay that is configured to latch following a trigger:
1� From the Home screen, press F1 (menu) to display the Main menu�
2� Highlight UNLATCH O1 or UNLATCH O2 and press ENTEO�
July 2016
Description
Parameter assignment of the output (like flow or total)�
Transmits programmed number of pulses per unit of measure�
Desired unit of measure for the output�
Time, in milliseconds, that the relay will remain in active state�
Leaves relay in triggered state until it is manually cleared�
(See "Clearing a Latched Relay"�)
Set the high value for the relay trigger�
Set the low value for the relay trigger�
Time in milliseconds (ms) that it will elapse before the relay
triggers if trigger condition is met�
Time, in milliseconds (ms) that the relay will remain triggered
after trigger condition is remedied�
ONLY ACTIVE IN MANUAL MODE: Bypasses any programmed
triggers to trigger relay� Will remain triggered until deactivated�
CTL-UM-01723-EN-01
Programming
Page 33