Table of Contents
Advertisement
VERSION 1.0.0
If you want a signal to appear in the Device Control Panel, check the DCP box next
2
to that signal.
Note: To use these I/O signals, you must integrate your automation equipment
with the robot controller.
Tap SAVE.
3
Forge/OS returns to the Device Configuration home screen. Make sure the robot appears
5
in the configured devices list and that it is enabled.
If you successfully completed this robot configuration, congratulations! You are ready to
control your robot in the Device Control Panel and Task Canvas apps.
© 2021 COPYRIGHT READY Robotics ALL RIGHTS RESERVED
47
Advertisement
Table of Contents
