Table of Contents
Advertisement
VERSION 1.0.0
Note: Enter the same IP address you plan to set on the ABB controller or come back to it
after changing the IP address later in this guide. By default, the IP address is set to
"172.16.255.251" by robot configuration files in the next section.
Insert a USB flash drive into the Forge hub as instructed on the screen. Use an empty
6
flash drive with at least 2GB of storage.
Tap Start Transfer and wait for it to finish.
7
Remove the USB drive when prompted.
8
© 2021 COPYRIGHT READY Robotics ALL RIGHTS RESERVED
22
Advertisement
Table of Contents
