Table of Contents
Advertisement
SECTION 35
EVT PRO 2.0
Upon start-up of the EVT PRO 2.0
laptop, the two devices should automatically establish the Wi-Fi communications data link.
This automatic link-up can take up to 1 minute. However, sometimes it may be necessary
to manually establish communications. Follow the procedure below in order to manually
establish the Bluetooth communications data link:
Note – If communications have not been established, repeat this procedure. If at that point
no connection has been established, please contact the Ventil Service Desk at
http://oms.ventil.nl/ClientLogIn.aspx
SECTION 36
EVT PRO 2.0
Upon start-up, if the EVT PRO 2.0
check for the latest version of software. If updates need to be made, then it will give the
user the option to install the downloaded new software version.
The software updating process is very user friendly and self explanatory. The system will
display the currently installed software version and the new downloaded software version.
The user can then decide if the new downloaded software version is to be installed by
following the on screen instructions.
SECTION 37
EVT PRO 2.0
Any device which is used to measure and determine quantitative measurements for the
purpose of quality should be calibrated annually to certify results. This is typical language
used by any certifying body for ISO, PED, or other quality group such as NB or ASME.
As such it is recommended that the EVT PRO 2.0
compliance and adherence to ASME / NB and other standards globally.
®
Operations and Technical Manual (Rev 1.0 – 2016)
EVT PRO 2.0
®
ESTABLISHING THE COMMUNICATIONS DATA LINK
1. Make sure the Hand Pump Case electronics is switched on.
2. After switching on the Hand Pump Case electronics, the Main Power Button Wi-
Fi Status Light (Refer to Figure 12.1 for location) will start flashing red.
3. Manually
reset
the
Communications Linkup Button for 5 seconds.
4. The Electronics has now been reset, and the red status light will flash red.
5. When the Wi-Fi connection has been established, the status light will glow solid
green. This may take up to 1 minute.
®
SOFTWARE UPDATES
®
CALIBRATION REQUIREMENTS
®
Hand Pump Case electronics and the EVT PRO 2.0
Hand
Pump
Electronics
®
detects an internet connection, it will automatically
®
be calibrated annually to ensure
NOT FOR COPY OR DISTRIBUTION
®
by
pressing
the
Wi-Fi
Page 47
Hide quick links:
Advertisement
Table of Contents
