GE EVT-Pro 2.0 Operation And Technical Manual page 24

SECTION 15 (Continued)
EVT PRO 2.0
® Operations and Technical Manual (Rev 1.0 – 2016)
EVT PRO 2.0
® - MOUNTING THE BRACKET TO A VALVE
Step 8
Install the Lift Sensor as shown.
Use the thumbscrew to secure the Lift
Sensor at the needed height.
The end of the Lift Sensor should rest
upon the Load cell plate and have free
travel.
Step 9
Use the clamp to secure the Acoustic
Sensor to the Bracket Assembly as shown.
Testing trials have shown that this is the
best location to place the Acoustic Sensor.
Ensure a good metal to metal contact.
Step 10
Insure NO part of the cable is in contact
with hot surfaces. Use the Velcro straps
(not shown) to secure the cable if needed
so that the cable and sensor leads are
supported and out of the way for testing.
NOT FOR COPY OR DISTRIBUTION Page 20