Installing Sensor In Ph8Hs Submersion Holder - YOKOGAWA OR8EFG User Manual

2.2.2

Installing Sensor in PH8HS Submersion Holder

To install the sensor in the submersion holder, proceed as follows:
(1) Pass the sensor cable through the sensor holder. If the submersion holder remains installed,
remove the sensor holder in any case.
For a pipe-mounting submersion holder without a cleaner, loosen the sensor holder nut to
remove the holder.
Nut
Removal of Sensor Holder (Arm Pipe used with option /MS1 or /MS2)
Sensor Holder
Sensor Holder Nut
Removal of Sensor Holder (Stainless Bracket used with option /MS3 or /MS4)
Figure 2.5
For a flange mounting submersion holder without a cleaner, remove the sensor holder by
loosening the two bolts securing the sensor holder to the flange (see Figure 2.6).
Figure 2.6
Sensor Holder
Removal of Sensor Holder (for Pipe Mounting Sensor without Cleaner)
Fixing Bolt
Flange
F2.6.ai
Removal of Sensor Holder (for Flange Mounting Sensor without Cleaners)
Right-angled Pipe Clamp
Arm Pipe
Bracket
F2.5.ai
< 2. Installation >
IM 12C07J01-01E 8th Edition : Apr. 27, 2020-00
2-4