YOKOGAWA OR8EFG User Manual page 18

Clamp (Screw)
Cleaner Holder
Sensor Holder
Figure 2.7 Removal of Sensor Holder (with Cleaner)
To install the sensor cable in the sensor holder, first remove the protector screwed onto the
sensor holder end and then remove the protective foam piece (for shipping; thus, it is not
necessary after the sensor is installed in the holder). Pass the sensor cable through the
O-ring then attach the O-ring to the sensor flange (see Figure 2.7).
When passing the sensor cable through the holder, if the inside of the holder is dirty or wet,
take special care to keep the cable dry by covering the sensor cable end with a polyethylene
bag or the like.
For details to install the sensor onto a holder, refer to relevant IMs.
Waterproof Cap
Pull out the sensor cable
and KCl solution supply tube.
Sensor Cable
KCl solution supply tube
Figure 2.8 Installing the Sensor Cable
F2.7.ai
Waterproof Cap Cover
Sensor Holder Pipe
Insert the sensor and cable
and KCl solution supply tube.
< 2. Installation >
Sponge
(Remove)
O-ring
Flange
Sensor Body
Protector
IM 12C07J01-01E 8th Edition : Apr. 27, 2020-00
2-5