2.2.2
Installing Sensor in PH8HS Submersion Holder
To install the sensor in the submersion holder, proceed as follows:
(1) Pass the sensor cable through the sensor holder. If the submersion holder remains installed,
remove the sensor holder in any case.
For a pipe-mounting submersion holder without a cleaner, loosen the sensor holder nut to
remove the holder.
Nut
Removal of Sensor Holder (Arm Pipe used with option /MS1 or /MS2)
Sensor Holder
Sensor Holder Nut
Removal of Sensor Holder (Stainless Bracket used with option /MS3 or /MS4)
Figure 2.4
Sensor Holder
Removal of Sensor Holder (for Pipe Mounting Sensor without Cleaner)
Right-angled Pipe Clamp
Arm Pipe
Bracket
F2.4.ai
< 2. Installation >
IM 12C04K01-01E
7th Edition : Feb.20,2020-00
2-3