Insinger RL-30 Technical Manual page 12

OPERATING INSTRUCTIONS
Chemical Connections:
The RL-30 is supplied with integral detergent and
rinse additive pumps and the chemical hoses are
located on the side of the dishmachine.
Detergent concentration should be between .25%
(.30oz/gal) and .30% (.38oz/gal). Note: Always
consult chemical
concentration.
Preparing for operation:
•
Locate the clear chemical pick up tubes on the
side of the unit
•
Identify the detergent pick up tube (smaller
diameter ID tube) and place it in the container
of commercial liquid detergent.
•
Place the rinse additive pick up tube (larger
diameter ID tube) in the container of commercial
liquid rinse additive.
RL-30 Undercounter December 2016
®
manufacturer for proper
PART 3 OPERATING INSTRUCTIONS
Priming the system:
•
The detergent pump is self priming and runs
during the rinse/fill cycle. The amount of
detergent dispensed is controlled by the speed
of the peristaltic pump. This can be adjusted by
turning the control screw.
•
The rinse additive pump is located behind the
front kick panel. The pump is a diaphragm type
pump and can be primed by inserting a
screwdriver into the screw on the front/top of the
pump, turning counter clockwise and then
depressing the screw to begin the manual
priming. Make several compressions until you
see the rinse additive solution entering the check
valve on the other side of the pump. The amount
of rinse additive that is added to the system can
be adjusted by turning the screw clockwise to
decrease and counterclockwise to increase.
Once set, the
automatically to the rinse system.
Rinse
pump
adjusting
screw
and prime
11 www.insingermachine.com 800-344-4802
Control screw
solution is then
Rinse pump
added