Installing The Batteries - DIG 400A Series Instruction Manual

Control Buttons
Select programming mode
Turn program(s) ON/OFF
Start/stop a manual cycle
Move left/right to select a value
Raise/lower the selected value

5. INSTALLING THE BATTERIES

1. Open the battery compartment cap by
turning it counter-clockwise.
2. Install two, fresh, brand name, AA
alkaline batteries (not included)
and note the proper direction of the
positive and negative orientation on the
underside of the controller.
3. Insert and screw the battery cap
clockwise. Make sure to securely
tighten the cover firmly by hand only.
The controller display appears with a
day, PM, and the hour digit flashing. The controller
is ready to be installed and programmed.
Battery replacement
4