Table of Contents
Advertisement
Battery Operated Controllers
Features
• Weekly or cyclical program
• Four start times per day in weekly mode
• Irrigation duration – from 1 minute to 12 hours in 1 minute increments
• Water budget from -95% to +95% in 5% increments
• Semi-automatic or manual operation
• Rain delay up to 30 days
• Simple, four button rubber keypad programming
• Withstands harsh climatic conditions
° Completely waterproof
• Can be mounted on a valve or on valve box wall
• Available with 3/4", 1", 1 1/2", 2" valves and 3/4" and
1" actuators to convert most manual antisiphon valves
• Available with rain sensor connection
• Operates using 1, 9-volt alkaline battery
• 2 year battery life
• Uses the S-305 DC solenoid and 18" wire
with internal manual bleed
740.000
710 & 740 Series
Single and Four Station
710.075
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for DIG 710 Series
Summary of Contents for DIG 710 Series
- Page 1 710 & 740 Series Single and Four Station Battery Operated Controllers Features • Weekly or cyclical program • Four start times per day in weekly mode • Irrigation duration – from 1 minute to 12 hours in 1 minute increments •...
-
Page 2: Table Of Contents
S-305DC, which has all captive components. Adapters are available to 6.3 Actuator assembly and installation ……………………………… 8 attach the solenoid to most brand name valves available on the market. DIG in-line 7. Using a sensor ……………………………………………………… 10 globe valves are also available in sizes 3/4” to 2” with the solenoid pre-installed. -
Page 3: System Components
3. system comPonents followed by a water droplet on the lower left side of the display. the droplet will flash momentarily To properly install a 710 and 740 series controllers, the and shut off. When the display flashes “12:00” the following components are needed: controller is ready to be programmed. -
Page 4: 4-Station Installation
Use DIG’s DC valve model 305DC-XXX or solenoid model S-305DC. If the S-305DC solenoid 8. Mount the controller – see page 5 for wall or valve is used, select the appropriate conversion adaptor for the valve(s) that will be used (see pg. -
Page 5: Actuator Assembly And Installation
each of red wire from the controller to each red wire on 2. Remove the 3/4” seat washer and then the 3/4” adapter, by turning the adapter the solenoids and each of the black wires from the counter clockwise. controller to each white wire on the solenoids using 3. -
Page 6: Using A Sensor
Note: Only a flashing character can be changed. siphon valve is operating correctly (the anti-siphon valve will open momentarily DIG controllers are programmed with the aid of four buttons: and then shut off). 7. turn the manual lever to the right to open. Slowly rotate the actuator counter... -
Page 7: Time Format (Switching Between Am/Pm And 24 Hour)
10. time format 13. selectinG WaterinG frequency (sWitchinG betWeen am/Pm and 24 hour) the default time format is AM/PM. there is this setting determines which days the controller will operate. Choose either “A) also a 24 hour time format option. It is a simple Watering According to the Days of the Week”... -
Page 8: Setting A Start Time - Water According To Days Of Week
C. CyCLICAL MOdE TO WATER EVERy x dAyS In this feature 0 days = program starts today; where 1 = program starts tomorrow, etc. (start can be delayed up to 30 days). Press until appears. Press several times Press until StARt I appears or the last opening time entered appears on the (to advance all the days of the week) until display. -
Page 9: Rain Off" (Shutdown)
19. sensor oPeration (s models only) to close the valve manually before the end of the manual cycle press until On appears again. Press to close the valve. to connect a sensor to the 700 series controllers, see section 7. In the current time mode, the sensor icon will appear when the sensor is tripped and “... -
Page 10: Maintenance, Troubleshooting And Repairs
Allow four weeks for repairs and shipping time. Repair of damaged units not otherwise SOLUtIOn: Adjust flow rates by turning valve adapter body slowly clockwise 1/4 within warranty may be refused or done at a reasonable cost or charge at the option of DIG turn at a time until valve closes CORPORAtIOn. -
Page 11: Technical Assistance
25. technical assistance Should you encounter any problem(s) with this product or if you do not understand its many features, please refer to this instruction manual first. If further assistance is required, DIG offers the following customer support: tECHnICAL SERVICE USA •...
Need help?
Do you have a question about the 710 Series and is the answer not in the manual?
Questions and answers