Programming; Setting Current Time And Date - DIG 400A Series Instruction Manual

8. PROGRAMMING

The 400A Series controller can be programmed to operate on any day of the week,
odd days or even days. In cyclical mode the 400A Series can also operate from every
1 hour up to every 12 hours or from once a day up to every 30 days. The
400A Series has four start times per day and durations from 1 minute up to 5 hours
and 59 minutes.
This section explains the programming features, and the steps necessary to assign
irrigation schedules. To program the controller use the
programming mode, the
change the value.
NOTE: Only a flashing value can be changed.
NOTE: If the last data entered stops flashing, press
programming and repeat the steps.

9. SETTING CURRENT TIME AND DATE

The controller can display the time in either a 12 or 24 hour format.
To change the time format, from the home screen:
1. Press the
(AM/PM disappears).
SETTING THE CURRENT TIME AND DATE
To enable the controller to operate properly, the current time and date must
be set.
1. Press the
of the week.
to make the entry flash and the
button for three seconds until the
button, until the
display switches format
icon appears along with the time and the day
8
to select the desired
buttons to
again to resume