Installing The Batteries; Pre-Installation Instructions - DIG 410BT Series Instruction Manual

1. INTRODUCTION
Thank you for purchasing DIG's 410BT Single Station Battery Operated
Controller. This manual describes how to get the 410BT series
controller up and running quickly. After reading this manual and
becoming familiar with the basic functionality of the controller, use the
manual as a reference for less common tasks in the future.
2. ABOUT THE 410BT BATTERY OPERATED CONTROLLER
The 410BT series irrigation controller employs the latest in Bluetooth®
technology using the free DIG BTT app for Android™ or iPhone®.
The 410BT is available as a single station battery operated controller
and is powered by two AA batteries that can last up to one year using
name brand alkaline batteries. The controller is enclosed in a compact,
waterproof housing to protect it from degradation.

3. INSTALLING THE BATTERIES

1. Open the battery compartment cap by
turning it counterclockwise.
2. Install two fresh, brand name, AA
alkaline batteries (not included)
and note the proper direction of the
positive and negative orientation on
the underside of the controller.
3. Insert and screw the battery cap
clockwise. Make sure to securely
tighten the cover fi rmly by hand only.
The controller will now appear on the
smartphone app and is ready to be connected to and programmed.
4. PRE - INSTALLATION INSTRUCTIONS
This manual covers installation for the 410BT-ASV and 410BT-MVA
models. If the 410BT-ASV model was purchased, go to section 5 for
installation instructions. If the 410BT-MVA was purchased, skip to
section 6 for installation instructions.
2
5. ANTI - SIPHON VALVE COMPONENT IDENTIFICATION
Manual fl ow control
External
bleed screw
3/4 in. Pipe
thread inlet
Anti-siphon valve
5.1 ANTI - SIPHON VALVE INSTALLATION
The 410BT-ASV can be installed directly to PVC pipe with two PVC
male adapters (not included). Inlet 3⁄4 in. FNPT, outlet 3⁄4 in. FNPT.
Rated operating pressure: 10 to 125 PSI
Recommended operating pressure: 10 to 80 PSI
NOTE: The 410BT-ASV must be installed at least 6 in. higher than the
highest sprinkler head on the system or back-drainage may occur.
Lid
FCC label
One button
for manual
run and reset
Battery
compartment cap
Solenoid
Anti-siphon cap
3/4 in. Pipe thread outlet
3