Reely ROAD Firestar Operating Instructions Manual page 49

"Neutral Auto": In the "Neutral Auto" position, the current position of the throttle/brake lever on the remote control
is taken as the neutral setting when the speed controller is switched on.
"Manual": In the "Manual" setting you can programme the speed controller's neutral and full acceleration setting for
forwards and reverse (when it is connected to the receiver) later when the speed controller is switched on for the first
time.
• After choosing "neutral auto" or "manual", press the "Enter" button. The settings made are transferred to the speed
controller and stored. The motor emits 5 beeps.
• Switch off the speed controller and disconnect the driving battery from the speed controller.
• Disconnect the speed controller from the programming card and connect it to the receiver again.
Ensure correct connection, since the speed controller will not work otherwise.
• Switch on your transmitter (check battery condition!). Put the trim controls in centre position. Put the throttle/brake
lever in neutral position and let go of it.
• Place the vehicle on an appropriate surface so that the drive can turn freely. Then insert the driving battery into the
vehicle and connect it to the speed controller.
• Switch on the speed controller. The motor emits a variety of sounds.
 Automatic recognition of the neutral position is active (setting "Neutral Auto")
• The motor emits a confirmation sound "DO-RE-MI" to show that the speed controller is active.
• Then the motor emits a further confirmation sound ("DA-LA-DA-LA"), the current throttle/brake lever setting is saved
as the neutral setting.
• The speed controller (and consequently the vehicle) is now ready for operation.
 Manual recognition of the neutral position is active (setting "Manual")
• The motor emits 3 beeps.
The following programming must be carried out within 15 seconds, as the speed controller will otherwise
return to the automatic recognition mode for safety reasons.
To programme the speed controller again the programming card must be reconnected and the "Manual"
setting must be selected under "Neutral auto/manual" and must be confirmed with the "Enter" button. Only
then can a new manual setting of the neutral and full throttle setting be carried out, as described in the
following.
• Now move the throttle/brake in the "full throttle forwards" position and keep it there for 2 seconds. The motor emits
3 beeps.
• Now move the throttle/brake lever to the "full throttle backwards" position and keep it there again for two seconds.
The motor emits a sound signal ("DO-RE-MI").
• At the end, move the throttle/brake lever to the neutral position and release it. After 2 seconds the motor emits a
sound signal ("DA-LA-DA-LA"), the throttle/brake lever settings for forward/reverse full acceleration is saved as is
the neutral setting.
• The speed controller (and consequently the vehicle) is now ready for operation.
49