Table of Contents
Advertisement
Uninstalling Serial Solutions PCI.
PCI Quad 422/485 Card
NOTE: These software settings must match the RS485 Multiplex Jumper
configuration, as described in the section "RS485 Multiplex Jumper Settings." in
Chapter 2, to ensure accurate and error free data transmission.
Force CTS True, determines whether the CTS handshake signal is INPUT from
the external serial device or is permanently forced true on the card. The serial
ports own RTS OUTPUT handshake signals are always taken out to the serial
port connector.
Defaults - When clicked this button resets the advanced properties to the
followed settings:
FIFO Off:
Transmit Buffers:
Receive Buffers:
Use Extended FIFO:
485 Mode:
To uninstall Serial Solutions PCI:
From Control Panel, open the Add/Remove Programs applet, then close the
Control Panel.
Select from the list Serial Solutions PCI.
Click the Add/Remove button.
Windows NT will then uninstall the Serial Solutions PCI applet without the need
for restarting.
On (unchecked)
1
8
Off (Unchecked)
Full Duplex
Chapter 8 Windows NT 4.0 Installation. x 44
Advertisement
Table of Contents
